Browse by Tags

Bolt Sleeving

Here we are sleeving a 700 Remington Bolt The receiver has been bored to .705 and printed. The sleeve has been turned to .704 and the bolt handle silver soldered to a seperate sleeve and then glued on the bolt body. We tested the glue job 3 times with a 2 pound hammer (no pun intended here rr :) and...

Posted to Bench-Talk General Forum (Forum) by Stan Ware on Thu, Mar 13 2008
Re: Barrel swapping

Tom, Let's talk about factory barrels first. Some times the Remington 700 come off hard and some people think that Remington uses a special lube or glue that hardens like Locktite. They do not..... they use a grease much like you would find in a grease gun. What happens is that then it goes to the...

Posted to Bench-Talk General Forum (Forum) by Stan Ware on Sun, Feb 24 2008
Finishing up truing of threads and lug area

Here we are doing the final trueing up of the thead area and single point cutting the threads. We are also tureing the integral lugs at the same time. Check it out at ... http://www.sgrcustomrifles.com/us/finishing-truing-threads-lug-area

Posted to Bench-Talk General Forum (Forum) by Stan Ware on Wed, Jan 9 2008

Page 1 of 1 (3 items)

Bench-Talk